PVC PET plastic cylinder container machine adjustment instruction

Our PVC PET plastic cylinder container machine model JC-200H is package by two ply wooden case for delivery. So the first thing client need to do is connect and install machine as original. This is the 8 steps working instruction for this automatic plastic cylinder machine.

1、Adjust the cylindrical indexing plate with the substrate to the size specifications of the plastic cylinder container machine. And then install the indexing plate onto the cylindrical closing plate;

2、Install the film feeding rubber wheel (configured according to the size of the cylinder);

3、Select a suitable pressure plate and install it into the central shaft for adjustment (to fit the cylinder being made);

4、Load the PVC roll material of the product into the feeding rack and pull it to the front end (the rubber wheel adjustment should not be too tight, just lightly press the film, and the gap on both sides should be consistent);

5、 Adjust the guide wheel to form a natural circular arc on the PVC sheet;

6、 Adjust the cutting blade to the appropriate position of plastic cylinder container machine;

7、 Lock the feeding rubber wheel tightly (do not tighten it too tightly, just tighten it slightly);

• The above seven steps have been completed, and the front-end production work has been done well;
• Next, turn on the power switch, heating switch, and feeding switch (the three switches can be independently controlled).
• When the temperature reaches the preset temperature, raise the heating plate to the edge bonding position of the cylinder
• adjust the glue, and set the length of the cylinder, feeding speed, quantity, and cutting time (the cutting time cannot be less than 0.36 seconds) in the human-machine interface (touch screen) to start production.
• In addition, there are two modes of operation in the human-machine interface (touch screen): automatic operation and manual operation.
• The control panel is also equipped with an automatic/manual operating system, which can be selected by the customer themselves.
• In the automatic operation interface, there is a system parameter where you can select the electric eye positioning (with more accurate length).
• When using the electric eye positioning, remove the photoelectric switch and install it on the electric eye pole of the machine head, and adjust the length accordingly.

8、 Adhesive free ultrasonic welding of plastic cylinder container machine

Firstly, adjust the height of the mold to the diameter of the product being made;

Raise the vibration generator to a distance of 3-4mm from the mold and connect it properly;

Turn on the operation switch and ultrasonic power switch on the touch screen.

Other operating methods are the same as above.

(During ultrasonic welding, the speed should not be too fast, the ultrasonic vibration power should not exceed second gear, and the feeding speed should also be matched with second gear.)