Clear plastic cylinder box machine operation

There are ultrasonic welding or gluing sealing models or pvc round tube box machine. Both design autoamtic clear plastic cylinder tube machine for  is very long. So we need to separated machine and package in two plywooden case for delivery. We need install machine before operation. This is the 3 steps for machine installation.

1、 Mold installation:

A set of molds of JC-200H clear plastic cylinder machine can be divided into two components. One is the front main mold and the other is the rear connection. Firstly, the installation of the main module is carried out with a screw lock in front of the spindle. And an auxiliary mold is installed in the machine sleeve at the shaft position to assist in casting the board.

2、 Pressure plate installation:

The position of the pressure plate is usually glued onto the press plate after it is replaced with a hot zone. Therefore, its installation speed is fast and accurate. In order to enable experts to quickly install the pressure plate on the roller and hot strip. And to enable the adhesive plate to bond quickly, the pressure plate has different characteristics. so it is necessary to avoid errors during clear plastic cylinder machine installation.

3、 Clear plastic cylinder machine copper plate debugging:

• During copper plate debugging, adjust the size of the mold to the reference circular plate surface of the copper strip, which is called the substrate.
• Use a screwdriver to loosen all screws and copper strips, and then lock the mold in the middle of the main board. The edge of the mold should have a sticky fluff layer (fabric adhesive production. Do not scratch the product due to the mold edge). Be careful not to get too close to the mold edge. And then push the copper strip onto the press mold so that the bearing on the copper strip is not too tight near the edge of the press mold, only close.
• Screw the screw onto the copper strip. And the copper strip must be tightly attached near the mold without too large gaps, especially for small products. Passing through large gaps can cause abnormal or excessive resistance at the front end of the raw material, resulting in abnormal manufacturing.
• During the production process, it is necessary to adjust the copper disc of the clear plastic cylinder to fix the diameter of the product. The copper disc is divided into two sets and one set is divided into two pieces. The two sets of copper discs cannot be mixed and shared because the size of each set does not match.
• Installation of disc wheels: As we all know, disc wheels are made of plastic materials and bearings. Its installation position is located on the axis between each board. Firstly, the size should be reasonable to ensure comparability of materials. Secondly, the distance between the two sides of the shaft should be equal.