Clear plastic tube machine Install Video No.9-10 contents
Working install video No.9—discharge clamp&Suction Cup
- Keep machine on manual situation. Move the discharge clamps to find out suitable “Current Position” and “Material-taking Position “ according to the working manual page 25&28
- These two position setting should be according to the length of plastic cylinder tubes. If the plastic tube that produce is long, the number should be smaller. If the tube is short,It is could be bigger. Make sure the material sheet could be under the middle of mold.
- The middle part of the video introduces each icon on the PLC interface. For clarify the functions of each icon, please refer to working manual page 35~39. If no need to change mold, please take record of original setting and then change setting number of each icon to see the action. If need to change bigger or small mold, the setting number need to be resented.
- Click “sucker rise” icon on manual screen page to check whether the sucker could goes up or goes down smoothly without being blocked by other components
- Place a plastic sheet into the material feeding tank. Make sure the raise part of the feeding groove can support the sheet and prevent it from falling.
- Adjust the distant of each bar. We will delivery 8 bars with machine. For small size material sheet install 4 or 6 bars is ok. For big size machine, please use 8 pcs bar for holding materials.
- Adjust the position of air blowing, make sure it can blow exactly onto the lower most sheets.
- Click “Open Suction Cup” icon on manual screen page to fetch a piece of sheet by sucker
- Adjust the position of material feeding block. Make sure the plastic sheet could falls down into the middle of 4 piece material feeding blocks of clear plastic tube machine.
Working install video No.10—check two positions setting
- After setting four piece material feeding blocks.
- Go back to “manual screen” page to recheck the “Current Position” setting number and “Material-taking Position” setting numbers we make before.
- Make sure the material sheet could be positioned under the middle side of mold before forming. And it can be fully ejected from the mold of clear plastic tube machine after forming.
